Fall Protection Requirements For Bucket Trucks

Well to be blunt it is what is says it is.

Fall protection requirements for bucket trucks.

It is this particular gotcha regulation where emphasis could be applied to trucks and trailers. Critical components are those in which a failure would result in a free fall or free rotation of the boom. Ensure that access gates or openings are closed. So why then.

And it can save your life that s what it can do for you. According to subpart l of the construction regulations specifically 1926 451 g 1 fall protection on scaffolding is not required until you are greater than 10 off the lower level. It is there to protect you in case of a fall. It applied an osha requirement not previously used for aerial lifts.

Several osha regulations can and do apply to fall protection for trailers and trucks. All fall protection plans must be prepared and approved by a qualified person and also re approved by a qualified person if anything in the protection plan changes. However one specific regulation is broad and encompasses a wide range of applications and instances. While working on aerial lifts at heights six feet or more above a lower level personal fall arrest systems when stopping a.

Fall protection what is and what can it do for you. Do not climb on or lean over guardrails or handrails. Fall protection for activities not in the construction industry is addressed in specific standards for the general industry shipyard employment marine terminals and longshoring industry this section highlights osha standards federal register notices rules and proposed rules preambles to final rules background to final rules directives instruction to osha staff letters of. Use a body harness or a restraining belt with a lanyard attached to the boom or bucket.

When working in aerial lift or boom type platforms including scissor lifts and bucket trucks the worker must either have a guardrail system in place where applicable or be tied off. On bucket trucks osha requires a full body harness and lanyard or a restraining device to prevent falls. Stand firmly on the floor of the bucket or lift platform. In august 2011 osha issued an memorandum regarding fall protection on aerial lifts during construction activities.

The provisions of the american national standards institute standard ansi a92 2 1969 section 4 9 bursting safety factor shall apply to all critical hydraulic and pneumatic components. Be sure proper personal fall protection is provided and used. Fall arrest systems used in construction work a device that permits an arrested fall is considered a fall arrest system. It s as simple as that.

Since construction workers in bucket trucks scissor lifts and boom type elevating work platforms are on a horizontal surface a positioning device may not be used for those workers.